Combining values from the two systems may result in nonconformance with this specification. The values stated in each system are not exact equivalents therefore, each system must be used independently of the other. Within the text, the SI units are shown in brackets. Normalizing or quenching and tempering the product will reduce the degree of variation.ġ.2 This specification is intended to supplement specifications for structural steel when so specified.ġ.3 This specification does not necessarily apply to all product specifications therefore, the manufacturer or processor should be consulted for energy absorption levels and minimum testing temperatures that can be expected or supplied.ġ.4 Two frequencies of testing (P and H) are prescribed.ġ.5 The values stated in either inch-pound units or SI units are to be regarded as standard. 50 hot rolled at 40 degrees F and including all ASTM shapes. The purchaser should, therefore, be aware that testing of one plate, bar, or shape does not provide assurance all plates, bars, or shapes of the same heat as processed will be identical in toughness with the product tested. A Modern Steel Construction / May 1996 Chart 1:Typical distribution chart for A572 Gr. ASTM A673/A673M, Frequency P, and shall meet a minimum average value of 27 J. The impact properties of steel can vary within the same heat and piece, be it as rolled, control rolled, or heat treated. Specification for Structural Joints Using ASTM A325 or A490 Bolts, 2004. 1.1 This specification establishes the procedure for longitudinal Charpy V-notch testing of structural steel and contains two frequencies of testing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |